D80 connector repair
D80 connector
Laser fiber connectors can be replaced in cases where connector can be broke or disconnected due to workplace accidents. In many cases, D80 connectors break off together with part of the laser fiber. When this happens, the fiber cannot be used. The laser machine has to be switched off immediately and laser fiber to be disconnected from the machine. Please be careful not to touch the fiber ends as the sharp glass fiber may cut your fingers. Do not point the broken fiber directly at your eyes. After handling the broken fiber, please wash your hands immediately as their might be tiny glass bits that might injure you.
When packing the damaged fiber, please conceal both ends with protection cap or end cap to prevent the handler from getting cut by the broken fiber. When received at our repair facility, we will inspect the fiber and check if there is any internal breakage in the fiber. We will also inspect both the D80 connector ends.
Most times, the D80 connector has to be replaced because it might have burnt out or the connector is broken. In the picture above, we will cut away the old connector and replace with a new D80 connector. This will be included in the basic fiber repair package. We will provide our customer with a primarily check report together with cost estimates of repairing the fiber.
At Gold Technic, we can also provide fiber termination services. If you have 50 meter fibers and would consider separating them into 2 pieces of 25meters, we can also provide this service.
By repairing your fiber, you can reduce manufacturing waste, be earth friendly, and reduce manufacturing cost. This is the best solution for any factory worldwide. Please contact us at sales@goldtechnic.com for more information on our products,